Home: Motoring > Chery Automobile Files Recall Plan, to Recall 53,882 Vehicles Starting November 27

Chery Automobile Files Recall Plan, to Recall 53,882 Vehicles Starting November 27

From:Internet Info Agency 2026-11-11 16:26:47

Chery Automobile has recently published its filed recall plan and will initiate the recall of affected vehicles starting November 27. The recall covers certain Tiggo 5x and Omoda series models produced between early June 2022 and the end of 2023, involving a total of 53,882 vehicles. The recall number is S2026M0146V, with the final letter V indicating that the recall was voluntarily initiated by the manufacturer. The recall is due to possible defects in the welding process connecting the rear axle trailing arms to the matching sleeves. Under extreme usage conditions, the welds may crack and detach, potentially causing loss of wheel control while driving. Chery will provide free verification of the rear axle production batch codes for vehicles within the recall scope, and vehicles confirmed to belong to the defective batch will receive free replacement of the rear axle assembly. In early October 2026, a 2023 model Omoda 5 in Johor Bahru, Malaysia, experienced the rear axle detaching along with the wheel while driving, with no casualties reported. One week later, Chery confirmed that vehicles of the same batch in the local market may have insufficient local welding strength in the rear axle trailing arms, initiated a recall of 8,878 vehicles locally, and announced a simultaneous investigation of vehicles from the same batch in the domestic and other global markets. The Malaysian Road Transport Department temporarily suspended the type approval and new vehicle registration for the model. In April 2024, a rear axle detachment incident involving the same model occurred in Malaysia. Local authorities conducted spot checks on 600 vehicles from the same batch and confirmed that 60 vehicles produced on August 15, 2023 required rear axle replacement. The investigation concluded that the cause was inadequate calibration of the rear axle welding equipment.

Editor:NewsAssistant